HP — Low-voltage power supply

Low-voltage power supply The low-voltage power supply circuit converts the AC voltage that is input from the electrical outlet to DC power and delivers it to each load in the printer. Figure 5-8 shows the low-voltage power supply circuit including the amount of voltage supplied to each component. The AC power is supplied to the low-voltage power supply by turning on the power supply switch (SW5). The AC power is converted to the DC power that the printer requires: G +24 V goes to the motors, solenoids, clutches, and the high-voltage power supply circuit. G +5 V goes to the laser driver PCB, the beam detect PCB, and the formatter.

G +3.3 V goes to the formatter, the sensors, and the ICs in the DC controller PCB. +24 V is divided into +24 VA, which is constantly sent from the low-voltage power supply circuit, and +24 VB, which stops power supply when the top cover or the front cover is opened. +24 VB goes to the fuser power supply circuit, high-voltage power supply circuit, and the motors and solenoids. +24 VB also functions as the door open detection signal (/DOPEN). The CPU detects the door open with the signal. Figure 5-8 Low-voltage power supply circuit C9660-90901 Chapter 5 Theory of operation 99