Toner level detection The printer monitors print cartridge life in several ways to ensure continued high print quality: G The number of developer rotations measures the usefulness (charge) of the toner. G The toner sensor monitors remaining toner, and informs the user of "low" or "out" conditions. G The number of photosensitive drum rotations measures the life of the photosensitive drum, which degrades slightly with each rotation. The cartridge life represented on the supplies status page and in the gauges on the control panel is a combination of all three of these components. The lowest remaining percent is the number reported to the customer.
However, information about which of these components is low or out is not reported. During the life of a print cartridge, the customer receives three different control panel messages: G OK . The cartridge has between 15 and 100 percent life remaining. G Order cartridge . The cartridge has 15 percent life remaining. In typical printing situations, this represents about 2 weeks of use. G Replace cartridge . One of the three components listed above has reached its end of life. The printer stops, and printing cannot continue until the cartridge is replaced. Developer rotations The developer rollers rotations are tracked on the print cartridge’s memory tag (e-label).
Tracking rotations enables the printer to signal that a print cartridge is low or out before the developer and/or toner is actually worn out, which would result in print quality defects. Over time, the toner loses its required properties due to excessive stirring and re-charging. Although the cartridge will correctly signal LOW or OUT because of wear, some toner might remain in the fresh toner hopper. In addition to toner wear, the developer roller experiences wear during its life, so developer life tracking is necessary. In situations where low-coverage documents are printed frequently, the developer rotations might cause a LOW message before the toner level reaches its low level.
Toner sensor For the first 75 percent of the cartridge life, toner depletion within the cartridge is calculated by pixel counting. An optical toner level sensor then tracks the final 25 percent of toner. The toner is measured and then reported on the toner gas gauge on the control panel or on the supplies status page. The transition from pixel counting to optical toner-level sensing causes no fluctuations on the toner gas gauge. Some toner might remain in the fresh toner hopper due to other cartridge components reaching their end of life. Photosensitive drum rotations Photosensitive drum rotations are also tracked on the cartridge’s memory tag.
Similar to the developer roller, tracking these rotations enables the printer to signal that a print cartridge is low or out before the photosensitive drum is actually worn out, when print quality defects would occur. The photosensitive drum might cause a low message when low-coverage documents are printed frequently. Tracking drum life is essential because of drum wear and the potential for overflow from the waste toner hopper if the photosensitive drum life is extended past its useful life. Figure 5-16 illustrates the toner level detection system. 110 Image formation system C9660-90901