Top cover To remove the top cover 1 Lift the top cover and remove the fuser. See “Replacing the fuser” on page 82 for instructions on removing the fuser. WARNING! The fuser might be hot. Wait 10 minutes for it to cool down before removing it. 2 Using fingers or needle-nose pliers, pinch and release the white plastic clips (shown in callout 1) on the damper arm on the left side of the cover. It is easier to pinch these clips if you tip the top cover forward slightly. 3 Disengage the tab shown in callout 2 and remove the retaining block. 4 Push the cover to the left to release the hinge pin on the right side. Then pull the cover to the right to release the hinge pin on the left side.
1 Figure 6-3 Removing and replacing the top cover (1 of 2) 2 Figure 6-4 Removing and replacing the top cover (2 of 2) C9660-90901 Chapter 6 Removal and replacement 145