Color registration detection unit To remove the color registration detection unit 1 Open the top cover and the front cover. 2 Remove the ETB. Note To protect the ETB from damage, always remove the ETB when removing the color registration detection unit. 3 Remove the control panel. See page 153. 4 Disconnect the connector shown in callout 1. 5 Remove the two screws shown in callout 2. 6 Remove the screw shown in callout 3 (this screw is located on the right side of the printer, underneath the plate where the screws in callout 2 are located). 7 Remove the control panel support assembly shown in callout 4, and then remove the color registration detection unit, which is located behind the stay.
CAUTION Do not touch the lens for the color registration detection unit. 162 Internal components (front) C9660-90901