To remove the drum home position sensors 1 Remove the drum drive gears. See page 166. 2 Disconnect the four connectors shown in callout 1. 3 Push each drum home position sensor holder (behind the connectors shown in callout 1) toward the rear of the printer, and flex it to remove the projection. Remove the sensor. 4 Disengage the two tabs holding each drum home position sensor in its holder, and remove the sensors. 1 Figure 6-34 Removing and replacing the drum home position sensors Note Calibrate the printer after reassembling the drum drive unit. See “Calibrate Now” on page 294. C9660-90901 Chapter 6 Removal and replacement 167