4 Lift the cartridge shutter bar, shown in callout 3, up and out of the printer. 5 Remove the four screws shown in callout 4. (In the picture below, the screw in the upper left corner is hidden by the gear.) 6 Disconnect the connector for each drum drive motor from the DC controller PCB. 7 Remove the drum drive motors. 4 3 Figure 6-37 Removing and replacing the drum drive motors (cyan motor shown) Note Calibrate the printer after removing or replacing the drum drive motors. See page 294. C9660-90901 Chapter 6 Removal and replacement 169