HP — DC controller PCB

DC controller PCB To remove the DC controller PCB 1 Remove the rear cover. See page 144. 2 Remove the top cover. See page 145. 3 Remove the rear top cover. See page 146. 4 Remove the left cover. See page 148. 5 Remove the DC controller shield. See page 155. 6 Remove the four screws shown in callout 1. 7 Disconnect all the connectors on the DC controller PCB, including the formatter ribbon cable shown in callout 2. CAUTION When removing the formatter ribbon cable, be careful not to tear it or to damage the connector. Use a flat-blade screwdriver to release the brown tab over the connection. Do not pull on the ribbon cable without releasing this tab. 8 Remove the DC controller PCB.

1 2 Figure 6-40 Removing and replacing the DC controller PCB Note Calibrate the printer after removing or replacing the DC controller. See “Calibrate Now” on page 294. 172 Internal components (left side) C9660-90901