HP — Low-voltage power supply

Low-voltage power supply To remove the low-voltage power supply 1 Remove the rear cover. See page 144. 2 Remove the top cover. See page 145. 3 Remove the rear top cover. See page 146. 4 Remove the left cover. See page 148. 5 Remove the DC controller shield. See page 155. 6 Remove the right cover. See page 150. 7 Remove the five screws shown in callout 1. (See the figures on the next page for the locations of four of the screws.) 8 Disconnect the connecting rod shown in callout 2. (See the next page.) 9 Disconnect the three connectors shown in callout 3. 10 Remove the low-voltage power supply. CAUTION When removing the low-voltage power supply, be sure that elements do not touch sheet metal.

1 3 Figure 6-44 Removing and replacing the low-voltage power supply, left side of printer (1 of 3) 176 Internal components (rear) C9660-90901