HP — Formatter case

Formatter case To remove the formatter case 1 Remove the rear cover. See page 144. 2 Remove the top cover. See page 145. 3 Remove the rear top cover. See page 146. 4 Remove the left cover. See page 148. 5 Remove the DC controller shield. See page 155. 6 Remove the right cover. See page 150. 7 At the rear of the printer, remove the eight screws shown in callout 1. 8 On the DC controller PCB, release the brown tab covering the formatter ribbon cable, and disconnect the cable (callout 2). CAUTION When removing the formatter ribbon cable, be careful not to tear it. Use a flat-blade screwdriver to release the brown tab over the connection.

Do not pull on the ribbon cable without releasing this tab. 9 Disconnect the connector shown in callout 3, and remove the formatter case. 178 Internal components (rear) C9660-90901