HP — High-voltage contact blocks

High-voltage contact blocks To remove the high-voltage contact blocks 1 Remove the rear cover. See page 144. 2 Remove the top cover. See page 145. 3 Remove the rear top cover. See page 146. 4 Remove the right cover. See page 150. 5 Remove the high-voltage power supply PCB. See page 185. 6 Remove the toner level detection PCB. See page 187. 7 Remove the screw shown in callout 1. 8 Unthread the wires from their guides, shown in callout 2. 9 Remove the high-voltage contact block, shown in callout 3. 10 Repeat for each of the four high-voltage contact blocks. 2 1 3 Figure 6-60 Removing and replacing the high-voltage contact blocks (cyan indicated) 188 Internal components (right side) C9660-90901