HP — Fuser drive unit

Fuser drive unit To remove the fuser drive unit 1 Remove the rear cover. See page 144. 2 Remove the top cover. See page 145. 3 Remove the rear top cover. See page 146. 4 Remove the left cover. See page 148. 5 Remove the control panel. See page 153. 6 From the left side of the printer, at the top and front of the printer frame, unhook the white tab that holds the hinge cover in place, and remove the hinge cover. (This tab is located above and to the right of the black drum drive unit.) 7 On the DC controller, disconnect the three connectors J1002, J1030, and J1034. See page 304. 8 Remove the three screws shown in callout 1.

9 Disconnect the connector shown in callout 2 (this connector is hidden in the picture; it is on the rear left side of the fuser drive unit). 10 Remove the fuser drive unit from the printer. 11 Remove the screw that attaches the hinge unit, and remove the hinge unit from the fuser drive. 192 Internal components (top) C9660-90901