HP — Pre-troubleshooting checklist

Pre-troubleshooting checklist The list below describes basic questions to ask the customer to help quickly define the problem(s). Table 7-1 Pre-troubleshooting checklist C9660-90901 Chapter 7 Troubleshooting 207 Environment G Is the printer installed on a solid, level surface? G Is the power supply voltage within ± 10 volts of the specified power source? G Is the power supply plug inserted in the printer and the outlet? G Is the operating environment within the specified parameters, as listed in Chapter 1 of this manual? G Is the printer exposed to ammonia gas, such as that produced by diazo copiers or office cleaning materials? G Is the printer exposed to direct sunlight?

Media G Does the customer use only supported media? G Is the media in good condition (no curls, folds, etc.)? G Is the media stored correctly and within environmental limits? Input trays G Is the amount of media in the tray within specifications? G Is the media set into the tray correctly? G Are the paper guides aligned with the paper? G Is the cassette properly installed in the printer? Print cartridges G Is each print cartridge properly installed? ETB and fuser G Are the ETB and fuser properly installed? Covers G Are the top cover and front cover closed? Condensation G Does condensation occur following a temperature change (particularly in winter following cold storage)?

If so, wipe affected parts dry or leave the printer on for 10 to 20 minutes. G Was a print cartridge opened soon after being moved from a cold to a warm room? If so, allow the printer to sit at room temperature for one to two hours. Miscellaneous G Check for and remove any non-HP components (print cartridges, memory modules, and EIO cards) from the printer. G If hardware or software configuration has not changed, or the problem is not associated with any specific software, contact the Customer Care Center (see Chapter 1). G Remove the printer from the network, and ensure that the failure is associated with the printer before beginning troubleshooting.

G For any print quality issues, calibrate the printer. See “Calibrate Now” on page 294 for instructions.