HP — Alphabetical printer messages

Table 7-2 Alphabetical printer messages (continued) C9660-90901 Chapter 7 Troubleshooting 215 Message Description Action INSTALL CARTRIDGE alternates with For help press The cartridge is either not installed or not correctly installed in the printer. 1 Insert the cartridge or make sure the cartridge is fully seated. 2 Press for detailed information. 3 Press and to step through the instructions. 4 If the error persists, replace the cartridge. 5 Verify that the connectors between the memory tag antenna, memory controller board, and the DC controller are seated properly. 6 Replace the antenna PCB for the indicated color. 7 Replace the memory controller PCB. 8 Replace the DC controller PCB.

Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294. INSTALL FUSER For help press The fuser is either not installed or not correctly installed in the printer. 1 Insert the fuser or make sure the installed fuser is fully seated. 2 Press for detailed information. 3 Press and to step through the instructions. 4 If the error persists, verify that fuser connector J4034 is good; replace it if necessary. 5 Replace the fuser assembly. 6 Replace the DC controller PCB. Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294.

INSTALL SUPPLIES For status press At least one supply item is missing or is not correctly seated in the printer and another supply item is missing, incorrectly placed, out, or low. Insert the supply item or make sure the installed supply item is fully seated. 1 Press and then press for help. 2 Follow the instructions on the display to locate and replace the missing or incorrect supply. 3 Press and to step through the instructions. INSTALL TRANSFER UNIT For help press The transfer unit is either not installed or not correctly installed in the printer. 1 Insert the transfer unit or make sure the installed transfer unit is fully seated. 2 Press for detailed information.

3 Press and to step through the instructions. 4 If the error persists, verify that the ETB connectors (J4017 on the ETB and J1014 on the DC controller PCB) are good. Replace connectors as necessary. 5 Replace the ETB. 6 Replace the DC controller PCB. Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294.