HP — Jam locations by error message

Jam locations by error message Use Table 7-4 to help pinpoint and clear specific paper jams. See Figure 7-2 for jam locations. Table 7-4 Error messages and associated jam locations C9660-90901 Chapter 7 Troubleshooting 235 Error message Jam location Action 13.01.00 JAM IN TRAY X 5 Media is delayed in the feed area of the specified tray. 1 Open the covers and the ETB. 2 Pull media by both corners to remove it. 13.02.00 JAM IN TRAY X 5 Media is stuck in the feed area of the specified tray. 1 Open the covers and the ETB. 2 Pull media by both corners to remove it. 13.05.00 JAM IN PAPER PATH 3 Media is delayed in the paper input path or has not reached the fuser paper sensor in the expected time.

1 Open the covers and the ETB. 2 Pull media by both corners to remove it. 13.09.00 JAM IN TOP COVER AREA 1 Media has crumpled into an accordion fold as it enters the fuser. 1 Open the top cover. WARNING! The fuser is hot, wait 10 minutes for it to cool down. 2 Firmly lift the two green handles on either side of the fuser to disengage the fuser rollers. 3 Open the fuser cover, and remove the media. 4 Firmly press down on the two green handles on either side of the fuser to re-engage the fuser rollers. 13.0A.00 JAM IN TOP COVER AREA 1 During a duplex print job, media was delayed in the output bin before it entered the duplex path. 1 Open the top cover. WARNING!

The fuser is hot, wait 10 minutes for it to cool down. 2 Firmly lift the two green handles on either side of the fuser to disengage the fuser rollers. 3 Pull media by both corners to remove it. 4 Firmly press down on the two green handles on either side of the fuser to re-engage the fuser rollers. 13.12.00 JAM IN DUPLEX PATH 2 During a duplex print job, media was removed from the output bin before it entered the duplex path, or media has entered the duplex path, but it is stuck. 1 Open the top cover and the front cover. (Do not open the ETB.) 2 Pull media by both corners to remove it. 13.21.00 JAM IN PAPER PATH 3 One of the covers is not completely closed.

Ensure both covers are closed before printing. 1 Open the covers and the ETB. 2 Pull media by both corners to remove it.