Avoiding paper jams Table 7-5 lists common causes of paper jams and suggests solutions for resolving them. Table 7-5 Common causes of paper jams C9660-90901 Chapter 7 Troubleshooting 237 Cause Solution Print media does not meet HP-recommended media specifications. Use only media that meets HP specifications. See Table 1-8, “Supported media specifications,” on page 29. A supply item is installed incorrectly, causing repeated jams. Verify that all print cartridges, the ETB, and the fuser are correctly installed. You are reloading paper that has already passed through a printer or copier. Do not use media that has been previously printed on or copied. An input tray is loaded incorrectly.
Remove any excess media from the input tray. Press media down in the input tray so it fits below the tabs and within the media width guides. Print media is skewed. Input tray guides are not adjusted correctly. Adjust input tray guides so they hold media firmly in place without bending it. If media heavier than 105 g/m2 (28 lb) is loaded into Tray 2 or Tray 3, the media might skew. Print media is binding or sticking together. Remove media, flex it, rotate it 180 degrees, or flip it over. Reload media into the input tray. Do not fan media. Print media is removed before it settles into the output bin. Reset the printer.
Wait until the page completely settles in the output bin before removing it. When duplexing, the print media is removed before the second side of the document is printed. Reset the printer and print the document again. Wait until the page completely settles in the output bin before removing it. Print media is in poor condition. Replace the print media. Print media is not picked up by the internal rollers from Tray 2 or Tray 3. Remove the top sheet of media. If the media is heavier than 105 g/m2 (28 lb), it may not be picked from the tray. Print media has rough or jagged edges. Replace the media. Print media is perforated or embossed. This media does not separate easily.
You might need to feed single sheets from Tray 1. Printer supply items have reached the end of their useful life. Check the printer control panel for messages prompting you to replace supplies, or print a supplies status page to verify the remaining life of the supplies. Media was not stored correctly. Replace the print media. Media should be stored in the original packaging in a controlled environment.