Jams in Tray 1 Table 7-6 Causes for jams in Tray 1 Jams in Tray 2 Table 7-7 Causes for jams in Tray 2 240 Paper path troubleshooting C9660-90901 Cause Solution Pickup roller is dirty, worn, or damaged. Clean the pickup roller. If it is still dirty after cleaning, or if it is worn or damaged, replace the pickup roller. Separation pad is defective. Clean the separation pad. If it is still dirty after cleaning, or if it is worn or damaged, replace the separation pad. Drive gears are damaged. Check the drive gears in the paper pickup unit. Replace the pickup drive assembly if the gears are damaged. Multi-purpose tray pickup solenoid is defective.
1 Disconnect the connector J1020 for the multi-purpose tray pickup solenoid from the DC controller PCB. 2 Measure the resistance between the cable-side connectors J1020-11 and J1020-10. 3 If the measured resistance is NOT about 160 ohms, replace the multi-purpose tray pickup solenoid. Pickup motor is defective. Replace the paper pickup drive assembly. Paper pickup assembly is defective. Replace the paper pickup assembly. DC controller PCB is defective. Replace the DC controller PCB. Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294. Cause Solution Separation tabs in the paper cassette are deformed.
Straighten the tabs on the front corners of the tray, or replace the cassette. Pickup roller is worn or damaged. Replace the pickup roller. Feed roller is dirty, worn, or damaged. Clean the feed roller. If it is still dirty after cleaning, or if it is worn or damaged, replace the feed roller. Drive gears are damaged. Check the drive gears in the paper pickup unit. Replace the pickup drive assembly if the gears are damaged. Cassette pickup solenoid is damaged. 1 Disconnect the connector for the cassette pickup solenoid from the DC controller PCB. 2 Measure the resistance between the cable-side connectors J1020-13 and J1020-12.
3 If the measured resistance is NOT about 160 ohms, replace the cassette pickup solenoid. Pickup motor is defective. Replace the paper pickup drive assembly. Paper pickup assembly is defective. Replace the paper pickup assembly. DC controller PCB is defective. Replace the DC controller PCB. Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294.