Light image Table 7-17 Causes for light images Light color Table 7-18 Causes for one color printing light Dark image Table 7-19 Causes for dark images 254 Image defects C9660-90901 Cause Solution Image density is not adjusted correctly. Increase the density for each color. Poor contact in the attaching bias contacts between the ETB and the high-voltage PCB. Clean the contacts. Replace them if they are still dirty or are damaged. Attaching roller is worn or damaged. Replace the ETB. Calibrate the printer after replacing the ETB. See “Calibrate Now” on page 294. High-voltage PCB is defective. Replace the high-voltage PCB. DC controller PCB is defective. Replace the DC controller PCB.
Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294. Cause Solution Poor contact in the transfer bias contacts between the ETB and the printer. Clean the contacts for the affected color. If the contacts are still dirty after cleaning or if they are damaged, replace the contacts or the ETB. Calibrate the printer after replacing the ETB. See “Calibrate Now” on page 294. Transfer charging roller is worn or damaged. Replace the ETB. Calibrate the printer after replacing the ETB. See “Calibrate Now” on page 294. Photosensitive drum is worn. Replace the print cartridge for the affected color. High-voltage PCB is defective. Replace the high-voltage PCB.
Laser/scanner unit is defective. Replace the laser/scanner for the affected color. Calibrate the printer after replacing the laser/scanner. See “Calibrate Now” on page 294. DC controller PCB is defective. Replace the DC controller PCB. Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294. Cause Solution Image density is not adjusted correctly. Decrease the density for each color. Color registration detection unit is dirty. Clean the lens on the color registration detection unit. Color registration detection unit is defective. Replace the color registration detection unit. DC controller PCB is defective. Replace the DC controller PCB.
Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294.