HP — EIO troubleshooting

Interface troubleshooting Communications checks Note Communication problems are normally the customer’s responsibility. Time spent attempting to resolve these problems might not be covered by the product’s Hewlett-Packard warranty. Refer the customer to the network administrator for assistance in troubleshooting network problems. If the printer is not connected to an MS-DOS-based host, proceed to Table 7-37, Communications check. Table 7-37 Communications check EIO troubleshooting If the printer contains an optional HP Jetdirect print server, and you cannot communicate with the printer over the network, verify the operation of the print server. Print a configuration page.

If the Jetdirect card does not appear under "Installed personalities and options" on the configuration page (indicated by the arrow in Figure 7-5), see the troubleshooting section of the HP Jetdirect Print Server Software Installation Guide . If the host system and printer are still not communicating, replace the formatter PCB and the EIO card and reconfigure the printer. If the problem persists, a protocol analyzer might be needed to find the source of the problem. CAUTION HP LaserJet printers are not designed to work with mechanical switch-box products without proper surge protection. These devices generate high transient voltages that cause permanent damage to the formatter PCB.

This circumstance is not covered by the Hewlett-Packard warranty. Figure 7-5 HP Color LaserJet 4600 series printer configuration page C9660-90901 Chapter 7 Troubleshooting 263 Check Action Is your computer configured to the parameters described in the configuration instructions? These parameters are required to communicate with the printer. Verify that the configuration of the computer's communications port matches these parameters. Note: If these parameters are not set properly, an error might display on the control panel.