HP — Installing an HP Jetdirect print server card

Installing an HP Jetdirect print server card You can install an HP Jetdirect print server card in the base model printer, which comes with an open EIO slot. 1 Turn the printer off, and disconnect all power and interface cables. 2 Locate an empty EIO slot. Loosen and remove the two retaining screws holding the cover for the EIO slot onto the printer, and then remove the cover. You will not need these screws and cover again. 3 Firmly insert the HP Jetdirect print server card into the EIO slot. Insert and tighten the retaining screws that came with the print server card. 4 Connect the network cable. Reconnect the power cable, and turn the printer on. 5 Print a configuration page.

In addition to a printer configuration page, an HP Jetdirect configuration page that contains network configuration and status information should also print. If it does not print, uninstall and reinstall the print server card to ensure that it is completely seated in the slot. 6 Perform one of these steps: • Choose the correct port. See the computer or operating system documentation for instructions. • Reinstall the software, choosing the network installation this time. 88 Printer memory C9660-90901