Fuser power supply circuit This printer uses an induction heating method to heat the fuser. Figure 5-5 shows the configuration of the fuser power supply. Figure 5-5 Fuser power supply circuit The fuser power supply has three main components: G Fuser sleeve. A high-frequency current flows through an induction heating coil in the fuser sleeve, causing the metal sleeve to heat. G Thermistors. Two thermistors are in the fuser sleeve: one in the center, and the other at the end. Each thermistor monitors the temperature in the fuser sleeve. G Thermoswitch. The thermoswitch is located at the bottom center of the fuser sleeve.
When the fuser is overheating, the switch opens, and power to the induction heating coil is shut off. Table 5-3 Fuser temperatures 96 Engine control system C9660-90901 Media Temperature Engine speed plain ~ 190° C (374° F) full speed overhead transparencies ~ 172° C (342° F) color ~ 185° C (365° F) monochrome 1/4 speed 1/2 speed thick ~ 185° C (365° F) 1/2 speed gloss ~ 167° C (333° F) 1/3 speed envelopes ~ 190° C (374° F) full speed