© Siemens AG 2010 BETA Protecting Miniature Circuit Breakers (MCBs) Busbars Standard 5ST3 6, 5ST3 7 Overview The busbar system with pin-type connections can be used for all 5SJ6 . . .-.KS and 5SY miniature circuit breakers with or without mounted auxiliary switch (AS) or fault signal contact (FC). Any free pins on the busbars can be made finger-safe by cover- ing with touch protection. Busbars in 10 mm 2 and 16 mm 2 versions are available. For further information on bus-mounting miniature circuit break- ers with residual current operated circuit breakers, please refer to the chapter"Residual current protective devices".
The 5ST3 7 busbar system with busbars that can be cut to any length required. The extremely flexible 5ST3 6 busbar system with fixed lengths also enables installation in any length as the busbars can be overlapped. No further need for time-consuming tasks, such as cutting, cutting to length, deburring, cleaning of cut surfaces and mounting of end caps. Benefits Between the devices, the busbar, located at the bottom and behind the conductor, provides an optimum wiring space with easy view of the inserted conductor. This enables easy control of connections.
The ability to overlap the busbar mounting enables a cross- section enlargement of up to 32 mm 2 using the respective components, 10 and 16 mm 2 . Combinations of any number of units are possible by overlap- ping the fixed-length busbars. The fact that the connection of the conductor is always clearly visible facilitates control and insertion of conductors of all pole types and considerably reduces mounting times. 19 19/31 Siemens LV 1 · 2010