© Siemens AG 2010 BETA Protecting Miniature Circuit Breakers (MCBs) Busbars according to UL 508, 5ST3 7 . . . - . HG Overview Products according to UL standards are used in North America, but also in several other countries. In particular when exporting machines or electrical switchgear and equipment to the USA, acceptance and delivery are possible only if the relevant UL standards are satisfied. The busbars are available in single-, two- and three-phase ver- sion with different pin spacings and with two cross-sections 18 mmІ and 25 mmІ. Infeed can be directly into the terminals of the miniature circuit breaker or through connection terminals.
The connection terminals are available in two versions – for di- rect infeed at the busbar or for infeed directly at the miniature cir- cuit breaker/fuse holder. Pins that are not required can be cov- ered with touch protection covers. The 5ST3 7. . .-.HG busbar system according to UL 508 and CSA is suitable for universal use worldwide with all 5SY and 5SP miniature circuit breakers for Supplementary Protection certified according to UL 1077 as well as for 3NW and 3NC fuse holders certified according to UL 512. Benefits Bus mounting with infeed through a connection terminal di- rectly on the miniature circuit breaker up to a conductor cross- section of 35 mmІ.
Infeed directly on the miniature circuit breaker up to a cross- section of 35 mmІ and connection terminal for connection di- rectly on the busbar up to a conductor cross-section of 50 mmІ. Suitable for universal use according to both IEC and UL stan- dards Can be used for 5SY, 5SP miniature circuit breakers and for Class CC, cylindrical and SITOR fuse holders UL-tested combination – device and busbar Different cross-sections 18 mmІ and 25 mmІ Bus mounting with infeed at the fuse holder for conductor cross-sections up to 35 mmІ 19 19/35 Siemens LV 1 · 2010