LVS-7500 External System Installation and Quick Start Guide 25. The InstallShield Wizard is complete. Click “Finish.” 26. Software and driver installation is complete. Click “Ok.” 27. Plug one end of the AC Line Cord into a power outlet. Connect the other end of the AC Line Cord into the 5-volt power supply box . WARNING: Use the 5-volt power supply box only; do not use the 24-volt power supply box supplied with the light tower interface unit (if purchased). Using the 24-volt power supply causes system failure. 28. Connect the power supply box cable to the power supply input on the LVS-7500 External System Readhead (see following diagram). 29.
Plug one end of the USB cable into the computer, and the other end into the USB cable connector on the LVS-7500 External System Readhead. LVS-7500 External System Installation and Quick Start Guide Page 20 of 45