LVS-7500 External System Installation and Quick Start Guide Step 2: Install the LVS-7500 External System Software Tools Needed: Installation flash drive LVS-7500 External System Readhead USB cable AC Line Cord Power Supply (5-volt) WARNING: The Light Tower Interface Unit, if purchased, is supplied with a 24-volt power supply. Use the 5-volt power supply only during the software installation steps in this section. Instructions: IMPORTANT: You must have administrator rights to install the LVS-7500 External System software.
Refer to the “Administration” section in the “LVS-7500 External System Operations Manual” (located on installation flash drive) for information on administrator rights. 1. Insert the installation flash drive into the computer’s USB port. 2. On the “AutoPlay” window, double-click “Run setup.exe.” LVS-7500 External System Installation and Quick Start Guide Page 8 of 45