MAINTENANCE AND SERVICE Vehicle cleaning Caution! Exterior cleaning Regular care helps maintain the value of the vehicle. Keep the following in mind when washing and cleaning the vehicle: VESPER ■ Do not wash the vehicle with acid cleaners, strong soap, strong chemical detergents, or gasoline. ■ In areas where road salt is used in winter, clean the underbody regularly in order to prevent the salt from building up and causing the acceleration of corrosion on the underbody and suspension. ■ Remember to close all doors, windows and the sunroof before washing the exterior. ■ Please clean the vehicle regularly to remove dirt and dust adhering to the paint surface and under the vehicle.
■ Please remove contaminants such as bird droppings, worm trail and road tar from the car body as soon as possible. Otherwise, these contaminants may damage the paint finish or trim of the vehicle after a long time. ■ Wash dirt off with a soft towel and plenty of water. Clean the vehicle thoroughly using a mild (special) vehicle detergent. ■ Do not clean vehicles with hot surfaces or under direct sunlight or sun exposure. Please wait for the exterior of the vehicle to cool before cleaning. Automatic washing Do not wash your vehicle in an automatic wash during the first month because the paint will not have hardened sufficiently.
An automatic car wash is a simple and quick way to clean your vehicle but it cannot reach everywhere. Hand washing the vehicle is recommended for achieving better results. Warning! ■ Do not wash the vehicle with the ignition on, this could cause an accident. ■ Do not flush the engine compartment with water, otherwise it may lead to serious accidents caused by electrical failure. When using the automatic car wash, make sure the outside rearview mirrors are folded. Failure to do this could result in damage to the vehicle. Caution! High pressure washing When cleaning the vehicle with a high pressure water gun, please always observe the operating instructions for the equipment.
This applies particularly to the operating pressure and the spraying distance. Do not hold the spray nozzle too close to soft materials, such as rubber hoses or seals. 267