Lynx Smart BMS 11.6.5. Configuring the reversed current setting Follow these steps after completing the voltage sense wire swap: 1. Open the VictronConnect app 2. Select your Lynx Smart BMS from the device list 3. Tap the cogwheel icon in the top-right corner 4. Select Current measurement direction 5. Set it to Reversed Without applying both the wiring and software modifications, the Lynx Smart BMS will not function as intended. Revere current setting in VictronConnect 11.6.6. Final check Before leaving the installation unattended:
Power on the unit and properly test and verify the unit's functionality Confirm correct operation Ensure all protective functions are active If you are not confident in performing the procedure, contact your local Victron representative for assistance. Page 48 Appendix