7. FUEL INJECTION PUMP/GOVERNOR 7.2.4 Assembly procedure Reverse the disassembly procedure and adjust the fuel injection timing finally. See (4) of 2.2.7. 7.2.5 Servicing points Point 1 [Disassemble] Block an entrance with the tape so that trash may not enter the fuel injection pipe and the fuel injection pump. Point 2 [Disassemble] After putting the I.D. marks on the gearing part of the pump drive gear and the idle gear with paint and so on, remove the gear installation nut. [NOTICE] Don't remove four flange bolts. [Reassemble] Reassemble the pump driving gear while checking the I.D. marks on the driving gear and idle gear.
Tightening torque of the gear installation nut 7-4 82E-5 – 98E-5 SERIES Model Nm {kgm} Lubricating oil application (thread portion, and seat surface) 3D82AE – 4D88E 78 – 88 {8.0 – 9.0} Not applied 4D94LE, (S)4D98E 113 – 123 {11.5 – 12.5}