mg MG6 — Starting the Vehicle

EMERGENCY INFORMATION Remove the ignition handset and switch off ALL electrical equipment of BOTH vehicles, then follow the instructions below: 3 Now start the engine of the vehicle with the discharged battery (DO NOT crank the engine for more than 10 seconds). 1 Connect the RED booster cable between the positive ( + ) terminals of both batteries. Connect the BLACK booster cable from the negative ( - ) terminal of the donor battery ( A ) to a good earth point (an engine mounting or other unpainted surface, for example), at least 0.5 m from the battery and well away from fuel and brake lines on the disabled vehicle ( B ) .

4 Once both engines are running normally, allow them to idle for two minutes before switching off the engine of the donor vehicle and disconnecting the booster cables. DO NOT switch on any electrical circuits on the previously disabled vehicle until AFTER the booster cables have been removed. 5 Disconnecting the booster cables must be an exact reversal of the procedure used to connect them, i.e.disconnect the BLACK cable from the earth point on the disabled vehicle FIRST. IMPORTANT DO NOT connect a booster cable to the negative (-) terminal of the discharged battery! This may result in damage the electrical components.

Battery replacement refers to the section ‘Battery’ in the ‘Maintenance’ Chapter. 2 Check that the cables are clear of moving parts of both engines, then start the engine of the donor vehicle and allow it to idle for a few minutes. NEVER turn on any electrical equipment on the started vehicle before removing the booster cables. IMPORTANT 160