Removing the Motherboard or Bottom Case (HP Authorized Service Providers Only) Required Equipment • Small Phillips screwdriver, preferably magnetized. • 5 mm hex driver. Removal Procedure 1. Unplug the ac adapter, if present, and remove the battery. 2. Remove these additional assemblies: • Floppy drive or other plug-in module (see page 2-4). • Hard drive (see page 2-5). • Display assembly (see page 2-9). • Keyboard (see page 2-20). • Heatsink and top case (see page 2-21). 3. If two screws are at the front corners of the CPU module, remove them. Caution • Remove and install the CPU module by holding it at the connector end (the right end). Do not pull or push on large components.
Otherwise, you could damage the connectors or damage pressure-sensitive components on the module. • Install or replace the CPU module thermal pad and spacer if they are missing or damaged. Be sure to use the thermal kit that is compatible with the CPU module. Components may be damaged if compatible parts are not used. See the table starting on page 4-3. 4. Unplug the CPU module from the motherboard. It is held by two connectors under the right end of the module. Note: The larger thermal pads are the same for both CPU types, but the corner spacers are different. Spacer Thermal pad CPU module, Pentium (T) CPU module, Pentium II (MD) Figure 2-20.
Two Types of CPU Modules and Thermal Kits HP OmniBook 2100/3000/3100 Removal and Replacement 2-25