Table 2-7. Removing Display Components HP OmniBook 7100 Removal and Replacement 2-21 Component Removal Procedures Additional Steps (See figure on page 4-5) Display Bezel Keyboard (page 2-8). Heatsink (page 2-9). Remove the bezel (page 2-11). Reassembly Notes: Install the hinge end caps into the case before attaching the bezel. Display Bracket, Left, Right, or Top Keyboard (page 2-8). Heatsink (page 2-9). Display (page 2-11). LCD module (page 2-11). Display Cable Keyboard (page 2-8). Heatsink (page 2-9). Display (page 2-11). LCD module (page 2-11). Reassembly Notes: Make sure the two-wire cable to the inverter PCA is under the main display cable near the hinge opening.
Display Case Keyboard (page 2-8). Heatsink (page 2-9). Display (page 2-11). LCD module (page 2-11). Reassembly Notes: Make sure the two-wire cable to the inverter PCA is under the main display cable near the hinge opening. Display Latch Keyboard (page 2-8). Heatsink (page 2-9). Display (page 2-11). LCD module (page 2-11). 1. Press the middle of the top bracket away from the latch until it unhooks from the case, then lift out the bracket. 2. Turn the case so the latch is closest to you. 3. Use your thumb to push the latch away from you until it rolls out of the case. This takes some force. Reassembly Notes: Make sure the ends of the spring point up when inserted into the case.
Make sure the latch locks in place. End Cap Keyboard (page 2-8). Heatsink (page 2-9). 1. Remove the bezel (page 2-11). 2. Lift out the end cap. Reassembly Notes: The mark molded into the cap should be vertical when the display is laying flat. Hinge Keyboard (page 2-8). Heatsink (page 2-9). Display (page 2-11). 1. Remove the bezel (page 2-11). 2. Remove the four screws from the bottom corners of the display brackets. Remove the hinges. Reassembly Notes: Install each hinge so the brighter half is attached to the display case. Do not install the outer screw until the bezel is attached. Icon PCA Plug-in module (page 2-3). Hard drive (page 2-5). Keyboard (page 2-8). Heatsink (page 2-9).
Display (page 2-11). Top case (page 2-14). Remove the two screws that hold the PCA. Inverter PCA Keyboard (page 2-8). Heatsink (page 2-9). 1. Do not remove the display assembly, but remove the bezel as described (page 2-11). 2. Unplug the two cables from the inverter PCA. 3. Remove the screw from the PCA and remove the PCA. Reassembly Notes: Make sure the insulator covers the inverter PCA. LCD Module See page 2-11.