printing from tray 3 Tray 3 is an optional tray on the hp business inkjet 3000dtn printer. It holds as many as 700 sheets of 16 to 72 lb bond. Tray 3 is designed to hold standard-to-legal size and standard-weight media. Loading certain types of special media (such as envelopes, cards, or heavy media) in tray 3 can cause jams and might damage the printer. Tray 3 is recommended if you frequently print multi-page documents or anticipate a high volume of printing. To load tray 3: Grasp the handle under the front of the tray. Slowly pull the tray out until it stops. Do not pull the tray completely out.
Push the blue tabs on the paper length guide and paper width guides, and slide them to their outermost positions. Place up to 700 sheets of paper (up to 70 mm or 2.7 inches, stacked) into Tray 3. Push the media as far back into the tray as it will go. Make sure the print-side of the media is facing down. Do not exceed the maximum stack height as indicated on the yellow label inside the tray on the right side. Push the blue tab on the paper length guide and paper width guides and slide them until they fit snugly against the media. Insert the tray into the printer until it closes completely. The printer can automatically detect some standard media sizes.
If this is the case, only one size will appear in the TRAY 3 SIZE options. If the size does not match the media you loaded in the tray, open the tray and make sure the media sits as far in as possible. Adjust the paper width and length guides so they fit snugly against the media stack. Close the tray. 3-10 hp restricted use and maintain