2-12 hp restricted setup & configure Install the printheads Ensure that the printer is turned on. Lift the printhead cover. Pull the latch forward and down to release the hook from the metal latch. Lift and push the latch toward the rear of the printer. Remove each printhead from its package and remove the protective tape and blue printhead cover from each printhead. Insert each printhead into its respective color-coded socket. Press in each printhead to ensure proper contact. Lift the latch forward so that the hook catches the metal latch. Push the latch towards the rear of the printer. Close the printhead and ink cartridge covers. Wait while the printer initializes.
When the initialization is complete, several alignment and calibration pages will print.
Install the printer software and connect the interface cable Windows Installing the printer driver if the USB cable is not connected Installing the printer driver if the USB cable is connected Installing the printer driver by using a parallel port Installing the printer driver by using a network connection Macintosh Installing the printer software on Mac OS 8.6 to 9.1 using a USB cable Installing the printer software on Mac OS 8.6 to 9.1 using a network connection Installing the printer software on Mac OS X Install the optional multipurpose tray Install the multipurpose tray in the Tray 1 location in place of the single sheet manual feed unit that came installed with the printer.
Install Tray 3 (optional on 3000/3000n models) Position the optional tray 3 base in the location where you want to place the printer. Tray 3 is already installed in the base. Align the tray 3 base with the opening in the printer and slide the tray and base into the printer until it snaps into place.