SLEEP FEATURE: TO SELECT THE OPERATING MODE: Press Sleep button to initiate the sleep mode. In this mode the selected temperature will increase by 2°F/1 (or 2)°C 30 minutes after the mode is selected. The temperature will then increase by another 2°F/1 (or 2)°C after an additional 30 minutes. This new temperature will be maintained for 6 hours before it returns to the originally selected temperature. This ends the Sleep mode and the unit will continue to operate as originally programmed. The Sleep mode program can be cancelled at any time during operation by pressing the Sleep button again. To choose operating mode, press Mode button.
Each time you press the button the unit cycles through the modes, Auto, Cool, Dry, and Fan. The adjacent indicator light will remain on once the mode is selected. The unit will automatically initiate the Energy Saver function under Cool, Dry, Auto (only Auto-Cooling and Auto-Fan) modes. Operating Instructions To operate on Auto feature: • When you set the air conditioner to AUTO mode, it will automatically select cooling or fan only operation depending on what temperature you have selected and the current room temperature. CHECK FILTER FEATURE: • The air conditioner will control room temperature automatically according to the temperature you’ve set.
Press Check filter button to initiate this feature. This feature is a reminder to clean the Air Filter for more efficient operation. The light will illuminate after 250 hours of operation. To reset after cleaning the filter, press the Check Filter button and the light will go off. • In this mode, the fan speed cannot be adjusted, as it’s automatically controlled according to the temperature setting and room temperature. To operate on Fan Only: • Use this function only when cooling is not desired, such as for room air circulation or to exhaust stale air (on some models).
(Remember to open the vent during this function, but keep it closed during cooling for maximum cooling efficiency.) You can choose any fan speed you prefer. ENERGY SAVER FEATURE: Press Energy Saver button to initiate this function. This function is available on COOL, DRY, AUTO (only AUTO-COOLING and AUTO-FAN) modes. The fan will continue to run for 3 minutes after the compressor shuts off. The fan then cycles on for 2 minutes at 10 minute intervals until the room temperature is above the set temperature, at which time the compressor turns back on and Cooling resumes. • During this function, the display will show the actual room temperature, not the set temperature as in the cooling mode.
• In Fan Only mode, the temperature is not adjusted. To operate on Dry mode: In this mode, the air conditioner will generally function as a dehumidifier. Since the conditioned space is a closed or sealed area, some degree of cooling will occur. Page 1 3