Auto Timer Mode Selector LED Display Check Filter Fan Speed Remote Signal Receptor Operating Instructions Energy Saver Power Button Temp/Timer Control Temp/Timer Control Sleep Mode (UP/DOWN) Button Press or hold either left ( - ) or right ( + ) button until the desired temperature is seen on the display. This temperature will be automatically maintained at the set temperature, between 62°F (17°C) and 86°F (30°C). If you want the display to read the actual room temperature, see “To Operate on Fan Only” section. Operating on FAN m ode: Use this function only when cooling is not desired, such as for room air circulation or to exhaust stale air (on some models).
(Remember to open the vent during this function, but keep it closed during cooling for maximum cooling efficiency.) You can choose any fan speed you prefer. During this function, the display will show the actual room temperature, not the set temperature as in the cooling mode. In Fan only mode, the temperature can not be adjusted. (MODE) Button To choose operating mode, press Mode button. Each time you press the button, a mode is selected in a sequence that goes from Auto, Cool, Dry and Fan. The indicator light beside will be illuminated and remains on once the mode is selected.
The unit will initiate automatically the Energy Saver function under Cool, Dry, Auto (only Auto-Cooling and Auto-Fan) modes. Operating on DRY m ode: In this mode, the air conditioner will operate in the form of a dehumidifier. Since the conditioned space is a closed or sealed area, some degree of cooling will continue. Operating on AUTO m ode: When you set the air conditioner in AUTO mode, it will automatically select cooling, heating (selected models only) or fan only operation depending on what temperature you have selected and the room temperature. The air conditioner will control room temperature automatically to hit the temperature set point you choose.
In this mode, the fan speed cannot be adjusted, it starts automatically at a speed according to the room temperature. (FAN SPEED) Button Used to select the Fan Speed in four steps - Auto, Low, Med or High. Each time the button is pressed, the fan speed mode is shifted. On Dry mode, the fan speed is controlled at low automatically. (ENERGY SAVER) Button This function is available on COOL, DRY, AUTO (only AUTO-COOL and AUTO-FAN) modes. The fan will continue to run for 3 minutes after the compressor shuts off. The fan then cycles on for 2 minutes at 10 minute intervals until the room temperature is above the set temperature, Page 16