Manual Operation (Without Remote Control) CAUTION The MANUAL button is intended for testing purposes and emergency operation only. Do not use this function unless the remote control is lost and it is absolutely necessary. To restore regular operation, use the remote control to activate the unit. Unit must be turned off before initiating the manual operation. Deflector rod Use the following steps to operate the unit manually: 1. Open the front panel of the indoor unit. 2. Locate the MANUAL CONTROL button on the right-hand side of the unit. 3. Press MANUAL CONTROL one time to activate the FORCED AUTO mode. 4. Press MANUAL CONTROL again to activate the FORCED COOLING mode. 5.
Press MANUAL CONTROL a third time to turn the unit off. 6. Close the front panel. Fig. 12 — Deflector Rod Manual Control Button Fig. 13 — Manual Control Button Range Fig. 11 — Range NOTE: DO NOT move the louver by hand. Doing so takes the louver out of sync. Should this occur, turn off the unit and unplug it for a few seconds, then restart the unit. Doing so resets the louver. CAUTION DO NOT put your fingers in or near the blower and suction unit side of the unit. The high-speed fan inside the unit may cause injury. Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations. 10