Run a test cycle Safety Instructions Features Operation Requirements Installation Instructions Washer Care Troubleshooting Washer Use Run a test cycle to make sure that your washer is properly installed. 1. Load about 6 pounds (2.7 kg) of laundry into the tub. 2. Select the Cycles knob to turn on your washer. 3. Turn the cycle selector to select the Rinse & Spin cycle. 4. Press the Start Pause button to start the test cycle. Your washer should not rock or vibrate excessively when water fills the tub or when washing or spinning. The washer should drain well during the spin cycle. Caution If you detect any water leaks while the washer is filling or draining, check the water connections.
See Connect the water hoses on page 19 or Connect the drain hose on page 21. If the washer rocks and/or vibrates excessively, level it again. See Level your washer on page 24. 26