Error Codes Your washer is equipped with an automatic error-monitoring system to detect and diagnose problems. Safety Instructions Features Operation Requirements Installation Instructions Washer Care Troubleshooting Washer Use Notice: 1. LED display: when an error occurs, Extra Rinse LED will flash and the wash process LEDs will indicate an error code 2. O - off, - blink, - Lighting 3. When an error occurs. Please refer to troubleshooting guide or installation instructions and try again. If error codes persist, call for service. 37 ERROR CODE POSSIBLE CAUSE SOLUTIONS Your washer takes more than 30 minutes to fill Washer.
Or when the water level sensor does not detect water level change after water is flowing for 5 min. • Make sure that the lid is not open. • Make sure that water is not leaking. See No water or not enough water on page 26. The unit takes more than 10 minutes to drain. • See Washer does not drain on page 27. The lid is open. Or the washer is not level. • Close the lid. • Level the washer. See “Step 4: Level your washer” on page 19. Your washer is out of balance more than three times during a spin operation. • See Washer vibrates or is too noisy on page27 . • See Washer vibrates or is too noisy on page27 .