Downloaded from https://www.everyspec.com MIL-STD-100E NOTICE 2 4 SEPTEMBER 1992 MILITARY STANDARD ENGINEERING DRAWING PRACTICES TO ALL HOLDERS OF MIL-STD-100E: 1. Make the following pen and ink changes: a. Page xv, paragraph 606. Change title to “Reinstating a superseded (old drawing, differen number) drawing.” b. Page xix, Appendix E, paragraph 40.4. Change to “Abbreviated distribution statements and export control warning notices.” c. Page 16, paragraphs 3.9,3.9.1,3.9.2, and 3.9.3. Delete all four definitions. d. Page 17, paragraph 3.4, lines 3, 6 and 7. Change “CAGE code” to “CAGE: Code”. e. Page 18, paragraphs 3.16 and 3.17. Delete both definitions. f. Page 22, paragraph 3.44, line 2.
Change “CAGE code” to “CAGE Code”. g. Page 24, paragraph 3.59, line 3. Change “CAGE code”’ to “CAGE Code”. h. Page 26, paragraph 3.70, line 2. Change “repairable” to “repair-able” and “MIL-STD-1388/1“ to “MIL-STD-1388-1“. i. Page 34, paragraph 6.4. Delete “Baseline” and changr “CAGE code” to “CAGE code”. j. Page 100-1, ” paragraph 101.1.1, line 3. Change the phrase “a component of a largcr unit” to “an element of a larger item. ” k. Page 400-8,” NOTE 1. Change “dash numbers” to “suffix identifiers”. 1. Page 400-9,” paragraph 406.10, Note 2, first sentence. Change to read “Source control drawing numbers, along with applicable suffixes, establish PINs.” m. Page 400–9, paragraph 406.10, NOTE 2.
In line 3 delete “identified and”, and in line 4 change “dash number” to “suffix identifier”. AMSC N/A DRPR DISTRIBUTION STATEMENT A. Approved for public release; distribution in unlimited.