Downloaded from https://www.everyspec.com MILSTD-100E NOTICE 2 6. NOTES (This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.) 6.1 Intended use. The requirements contained herein apply to hardcopy drawings, digital data file(s), associated lists and textual data resulting from the contractual application of DOD-D- 1()()(), MIL-T-31000 or MIL-T-47500. 6.1.1 Applicability packtage element is design. The current document specifying engineering drawings as a technical data MIL–T-31000. DOD–D–1000 and MIL–T–47500 are inactive for new 6.2 Acqu isition requirements. 6.2.1 Issue of DODISS.
When this standard is used in acquisition, the applicable issue of the DODISS must be cited in the solicitatition (see 2.1.1, and 2.2). 6.2.2 Tailoring guidance. To ensure proper application of this Standard, invitations for bids, requests for proposals, and Contract Data Requirements Lists (CDRLs) must tailor the requirements in Chapters 100 through 700” to exclude unnecessary requirements. It is essential (hat the contractual applicability of the numerous referenced documents, as contained herein. especially Chapter 100, be as definitive as practicable.
Although the I manner and extent of such tailtoring will vary in accordance with program or end–item requirements, the following is provided as a minimum for consideration in acquisition documents: A. Media (See 101.16 and 704 including NOTE) (1) Hard Copy: originals reproductions (2) Digital Data: magnetic tape, IGES (type) tramsmission B. Drawing Format (See ANSI Y 14.1) (1) Contractor (2) Government 31 Supersedes page 31 of 30 September 1991