MIL-STD-100E — MIL-STD-100E Notice 2: Engineering Drawing Practices PDF Download

Downloaded from https://www.everyspec.com MIL-STD-100E NOTICE 2 NOTE 7: Under certain contracts or purchase orders, Government design or procuring activity approval may be required for the preparation of Source Control Drawings. See Appendix D for Qualification Provisions as applied to Source Control Drawings where the Government Activity (Army, Navy, Air Force) is identified by CAGEC and Name in the title block or indicated as “CURRENT DESIGN ACTIVITY”. NOTE 8: A source control drawing provides an engineering description, qualification requirements, and acceptance criteria for a vendor item that exclusively provides the performance.

installation, and interchangeability characteristics required for specific critical applications. Included on the drawing is a listing of approved sources of supply, their addresses, CAGE Code. and item identification for vendor items that have been qualified and approved for use in a specific application. The source control drawing number and applicable suffix identifiers establish the PIN. See 406.10, Note 2. NOTE 9: Unless otherwise specified. the listing of manufacturing sources of supply on a source control drawing by a Government design activity is performed in accordance with Appendix D. I NOTE l0: See also 101.15.2 and 101.15.3 on Printed Board Drawing. 204.2 Government peculiar.

The following drawing types (or variations thereof) describe program or Government peculiar requirements for drawing types. See also Appendix F. 204.2.1 Inseparable assembly drawing. An inseparable assembly drawing delineates items (pieces) which are separately fabricated and are permanently joined together (as in welded, brazed, riveted, sewed, glued or other processes) to form an integral unit (part) not normally capable of being disassembled for replacement or repair of the individual pieces.

An inseparable assembly drawing may be prepared in lieu of individual monodetail drawings for inseparable (welded, brazed, bonded, riveted, sewn, glued or other processes) assemblies intended to be procured and replaced us a unit. Example: A welded or riveted bracket, a wood, metal or plastic chest, or a canvas case may be covered by an inseparable assembly drawing without separate detail drawings. See Figure 200-3. (See ASME Y14.24M, Assembly Drawing) 200-5 Supersedes page 200-5 of 30 September 1991