MIL-STD-100E — MIL-STD-100E Notice 2: Engineering Drawing Practices PDF Download

Downloaded from https://www.everyspec.com MIL-STD-10OE NOTICE 2 d. QTY: The quantity of each item which is necessary to make up one unit of the package. e. NAME OF ITEM: Nomenclature of each item contained in the package. f. DWG NO.: The drawing number of each item listed. g. CAGE CODE: The CAGE Code assigned to the drawing for- the items listed. If the CAGE Code is the same as that in the drawing title block it may be omitted here. h. PIN: The PIN of each item listed. i. STOCK NUMBER: The National Stock Number of each item listed. If no Stock Number exists, leave blank. j. TITLE BLOCK: The nomenclature of the package contents drawing. 204.2.6 Software and firmware data.

Drawings defining software that will be or are intended as resident in a firmware device shall be prepared as Software Drawings for the master media and Altered Item Drawings for the firmware. 204.2.6.1 Software drawing. A software drawing describes the characteristics of the software and its master media, used for programming each applicable device or assembly. Software programs will not be defined as truth tables but rather identified as to be supplied as a duplicate of the master media in digital form. I 204.2 .6.1.1 software drawing requirements. The drawing shall specify the type of media (for example, magnetic tape or disk), media PIN. and version identification of the software.

In addition, the media characteristics (for example, type, number of tracks, density and size) and the characteristics and formats of the information stored on the media shall be fully described. Any other information necessary to completely describe how the master media is to be used shall also be included. The PIN of the master media shall be shown as a suffixed identifier of the software drawing. If more than one version of the software is to be installed or used, the drawing shall provide separate suffixes for each version. The notation SOFTWARE DRAWING shall be placed above the title block. See Figure 200-8.” 200-8 Supersedes page 200-8 of 30 September 1991