MIL-STD-100E — MIL-STD-100E Notice 2: Engineering Drawing Practices PDF Download

Downloaded from https://www.everyspec.com MIL-STD-100E NOTICE 2 406.15.4 Bulk items idenentification Bulk items shall be identificd by a discrete identifier in accordance with 406.10 or 406.15. Where practicable, the quantity or measurement of material shall be included. Separate engineering drawings shall not be prepared for speeific quantities of bulk items, unless the conditions specified in 406.15.4.1 apply. 406.15.4.1 Drawings for bulk items Any bulk item, requiring assignment of National Stock Number and not having an associated PIN system, shall require a drawing and PIN if no supporting documentation exists (military specification or standard, or non-Government standard).

Bulk items, which have a finite shape, such as wire, tubing. cable, chain, tape and hose, and are required for logistics support, shall be identified as a component an assembly or installation drawings through a discrete PIN consisting of a document number and suffix identifiers, as applicable to identify each size, length or quantity used in the assembly or installation. Accordingly. the absence of controlling documention and PIN system shall require a separate drawing. Separate drawings shall not be preptared for bulk items covered by existing specifications or standards except where there is a support requirement and an absence of a PIN system.

400-14 Supersedes page 400-14 of 30 September 1991