MIL-STD-100E — MIL-STD-100E Notice 2: Engineering Drawing Practices PDF Download

Downloaded from https://www.everyspec.com MIL-STD-100E NOTICE 2 be used in all its applications. The addition of the note constitutes a change: therefore, an applicable entry in the revisions block in accordance with Chapter 600” is required. 502.3 Drawings of multiple items. When not all of the items on a drawing are replaced, the notation information cited in 502.1 and 502.2 shun be contained in a drawing flagnote or table for each affected item.

502.4 Superseded drawing When a drawing is redrawn (new original with the same drawing number), and the superseded drawing is to be retained, the word “SUPERSEDED” shall be added to the old original above the title block as shown in Figure 500-4 and in accordance with 502.5. Revisions block entries shall be in accordance with Chapter 600.” 502.5 Notation size. Notation cited in 502.4 shall be stamped or printed in characters the same size as the lettering height of the drawing title. substitute to permit establishment of alternate sources of supply, permit production of parts by alternate methods of manufacture or permit fabrication of items with substitute parts or materials.

If parts are identified on the field of the drawing by part number callout, substitute parts or assemblies shall be identified directly or by reference, on assembly or installation drawings as follows (See 406): 503. ldentifying substitute parts. Drawings and PLs show parts, materials, or methods as 127XXXXl - PREFERRED 128XXXX3 - SUBSTITUTE o r 128XXXX3 - ALTERNATE 504. Distribution Statements. Distribution Statements and associated Export Control Warning Notices shall be in accordance with MIL-STD-1806 and located on engineering drawings and associated lists in accordance with Appendix E. Distribution Statements shall be as specified by the Government design or procuring activity. 505.

Security classification and notation. Security classificatition and notations shall be in accordance with Appendix B. 506. Proprietary legends on drawings. Proprietary (limited rights) claims shall be marked on applicable sheets of drawings with the appropriate approved legend as required by applicable Defense Federal Acquisition Regulation (DFAR). 500-3 Supersedes page 500-3 of 30 September 1991