Department of Defense MIL-STD-1311D — MIL-STD-1311D Test Methods for Electron Tubes — DoD Standard Manual PDF

Downloaded from https://www.everyspec.com MIL-STD-1311D METHOD 2214B (Power and transmitting tubes) 1. Purpose. To measure that part of the radio frequency output power flowing from the tube output terminals into a dissipative load. Most accurate monitoring can be achieved when the dissipative load is matched to the transmission line in which the power measurements are made. This method is for higher frequency measurements over a frequency range from 225 to 1,250 MHz. 2. Procedure A (for power amplifier). a. For circuit, see figure 2214-2. b. Neutralization of inherent feedback may be accomplished by known techniques to maintain stable tube operation. c.

Dotted blocks are optional devices which may be used to initially establish appropriate circuit performance and frequency. d. The frequency meter setup shown can be located in either of the two indicated positions in the driver or output side. e. The rf input or rf output circuits can be either distributed line such as strip-line, coaxial cavity, lumped parameter amplifiers, etc., as defined in the TSS. f. Power measurements should be accomplished by either calorimetric or other suitable power techniques to an accuracy of ± 5 percent. 2.1 Test procedure. - a. The grid bias is set to the specified value or adjusted for maximum output.

If power gain is to be determined, gird bias shall be set to specified value. b. The anode and screen supplies are applied and adjusted to the specified values. c. The tuning and output coupling are adjusted to obtain the highest possible output power. d. If specified, the driving power, or input rf power is given by the difference between the forward and reflected values measured by the reflectometer (see figure 2214-2 test circuit notes). 2.2 Specified TSS test conditions. a. Electrode voltages. However, when the TSS does not specify grid bias, the tube may be operated class C, since the cutoff would vary from tube to tube. b. Electrode currents or ranges of current. c.

Frequency of the rf output. d. Maximum allowable driving power. e. Type of input/output circuit (see 2e above). _________ 1/ Where the measurement of useful output power is of a linear amplifier, single sideband, HF (normally up to 32 MHz) and precedes an intermodulation distortion (IM) measurement, this method does not apply. RF USEFUL POWER OUTPUT 1/ METHOD 2214A 2214-1 19 September 1973