Department of Defense MIL-STD-1311D — MIL-STD-1311D Test Methods for Electron Tubes — DoD Standard Manual PDF

Downloaded from https://www.everyspec.com MIL-STD-1311D METHOD 3249 OPERATION, HYDROGEN DIODES Cathode and reservoir heaters shall be operated at the voltages specified. During operation, the specified number of rejectable arc-backs (for rectifiers) and arc-backs due to voltage hold-off deficiency (for other diodes) shall not be exceeded and there shall be no evidence of detrimental anode heating. 1. Rectifier operation. Each tube shall operate satisfactorily and without rejectable arc-backs in the full-wave rectifier circuit shown on figure 3249-1 under the conditions specified.

A rejectable arc-back is one which has a current in the reverse direction whose peak value is not less than five times the peak forward anode current obtained during this test. In the test circuit, the source impedance shall be such that the peak value of the steady-state current in the shorting circuit, when all tubes are short circuited, shall not be less than 7.5 times the peak forward anode current obtained during this test. The arc-back detector shall be capable of detecting a rejectable arc current whose duration is equal to or greater than one-quarter cycle of the frequency of the applied voltage. Unless otherwise specified, the frequency of operation shall be 50 to 60 Hz. 2.

Clipper diode operation. Clipper diodes shall be tested in a thyratron modulator circuit shown on figure 3249-2 under the conditions specified for epy, ib, tp, prr, and the resonant prr (resonant charging frequency). 3. Pulse transformer backswing diode operation. Pulse transformer backswing diode shall be operated in the thyratron pulse modulator circuit shown on figure 3249-3 to give the conditions specified for epx, ib, tp, and prr. 4. Charging diode operation. Charging diodes shall be operated on a thyratron pulse modulator circuit as shown on figure 3249- 4 under the specified conditions of epy, ib, ip, pulse repetition rate, and resonant prr (resonant charging frequency). 5.

Hydrogen diodes may be operated simultaneously provided all electrical conditions are met for the individual operation and life-test requirements, for example, tubes may be operated in a pulse modular circuit; one as a charging diode, one as a clipper diode, one as a clipper, and one as a backswing pulse transformer diode, or any combination. NOTE: Value of capacitor adjusted to yield ib as specified. FIGURE 3249-1 Circuit for operation of rectifiers. METHOD 3249 3249-1 19 April 1968