Department of Defense MIL-STD-1311D — MIL-STD-1311D Test Methods for Electron Tubes — DoD Standard Manual PDF

Downloaded from https://www.everyspec.com MIL-STD-1311D INTERMODULATION OR CROSS MODULATION METHOD 4263 (Traveling-wave tubes) 1. Purpose. This test is designed to measure the degree of intermodulation or cross modulation present when two or more signals are passed through a traveling-wave tube. Intermodulation is defined as that phenomenon of non-linear effects producing new frequencies of mF1 ± nF2 (m and n are integers) when two unmodulated signals of frequencies F1 and F2 are passed through a microwave amplifier.

Cross modulation is defined as that phenomenon which results in changes of the output level of one unmodulated signal when other unmodulated signals are simultaneously applied to the input. 2. Intermodulation. 2.1 Test circuit. FIGURE 4263-1. Intermodulation. 2.2 Procedure. With the TUT inserted in the circuit shown on figure 4263-1, signals of specified power and frequency at F1 and F2 are simultaneously applied to the TUT input. The power output of each frequency component is measured in accordance with method 4250. The filter shall reject all signals except those at the desired frequency. 3. Cross modulation. 3.1 Test circuit. FIGURE 4263-2. Cross modulation.

METHOD 4263 4263-1 19 April 1968