Downloaded from https://www.everyspec.com MIL-STD-1311D SALT SPRAY (CORROSION) Note: This test is normally performed as a "Qualification only" test. 1. Procedure. Except as specified herein, tubes shall be tested in accordance with method 101 of MIL-STD-202, test condition A, 20 percent salt solution. When the specimens are suspended from the top, suspension shall be by materials which are nonreactive to the salt solution. At the completion of the exposure, the samples shall be thoroughly dried at room temperature prior to examination. 2. Acceptance criteria.
Following this test, the tubes shall be examined and shall show no conditions which may interfere with operation and shall meet all end-point test limit(s) specified. METHOD 1006 METHOD 1006 1006-1 9 April 1968