Downloaded from https://www.everyspec.com MIL-STD-1311D SPURIOUS SIGNAL METHOD 5433 (Vidicons) 1. General. a. The tube shall be tested in a camera system with associated monitors as shown on the block diagram of figure 5426-1. b. The test pattern shown on figure 5433-1 shall be used when performing this test. c. Align the tube in accordance with method 5437. d. Cap lens and adjust black level for 20 percent setup. Uncap lens and adjust video gain control to see all steps of gray scale on ECA resolution chart, 1956, or equivalent. 2. Spurious-signal criteria. a.
There shall be no blemishes or spurious responses in zone 1 of the test pattern resulting in a video signal in excess of A or B of the peak black-to-white signal as indicated in the following table: b. There shall be no white spot in zone 2 with a video signal greater than D of the peak black-to-white signal and greater than two raster lines in size. c.
Low contrast white spots having a video signal between C and D of the peak black-to-white signal, or white spots having a video signal greater than D of the peak black-to-white signal and one to two raster lines in size as well as black spots having a video signal greater than E of the peak black-to-white signal, are allowed as shown in the following table: d. Separation between any two spots shall be greater than 22 raster lines in any direction. METHOD 5433 5433-1 28 March 1975 Size (in number of raster lines in any dimension) Percentage of video signal Over 3 3 to 1 A B Size (in number of raster lines in any dimension) Number allowed in Zone 2 Over 4 4 to 3 2 to 1 None 2 5