MIL-STD-1504C Abrasive Blasting Standard Practice Manual PDF (USAF) (EN)

Downloaded from https://www.everyspec.com METRIC MIL-STD-1504C (USAF) 01 March 2007 SUPERSEDES MIL-STD-1504B 8 June 1989 DEPARTMENT OF DEFENSE STANDARD PRACTICE ABRASIVE BLASTING This document is inactive for new design. AMSC: N/A AREA: MFFP

Стр. 1

Downloaded from https://www.everyspec.com MIL-STD-1504C FOREWORD 1. This Military Standard is approved for use by 309MXSG/MXRL, Department of the Air Force and is available for use by all departments and agencies of the Department of Defense. 2. This standard provides guidance for the Air Force repair process, acquisition, and manufacture of parts and/or spare parts on the landing gear of all military aircraft. 3. Beneficial comments, recommendations, additions, deletions, clarifications, etc. and any data that may improve this document should be sent to: 309MXSG/MXRIL, Hill AFB, UT 84056-2609 or e-mailed to: 309MXSG/MXRL@hill.af.mil .

Since contact information can change, verification of currency of this address information through ASSIST Online database at http://assist.daps.dla.mil . ii

Стр. 2

Downloaded from https://www.everyspec.com MIL-STD-1504C CONTENTS PARAGRAPH PAGE FOREWORD ii 1. SCOPE 1 1.1 Scope. 1 1.2 Abrasive blast use. 1 2. APPLICABLE DOCUMENTS 1 2.1 General. 1 2.2 Government documents. 1 2.2.1 Specifications, standards, handbooks & commercial item descriptions. 1 2.2.2 Other Government documents, drawings, and publications. 1 2.3 Order of precedence. 2 3. DEFINITIONS (Not Applicable) 2 4. GENERAL REQUIREMENTS 2 4.1 Abrasive blasting. 2 4.2 Cleaning. 2 4.3 Surface defects. 2 4.4 Blasting method. 2 4.5 Corrosion. 2 4.6 Materials and equipment. 3 4.6.1 Materials. 3 4.6.2 Equipment. 3 5. DETAILED REQUIREMENTS 3 5.1 Masking. 4 5.2 Distortion and warpage.

4 5.3 Compressed air. 4 5.4 Process flow. 4 5.5 Glass bead blasting. 4 5.7 Silicon and aluminum blasting. 5 5.8 Plastic media blasting. 5 5.9 Quality control responsibility. 5 5.9.1 Quality control responsibility. 5 5.9.2 Requirements. 6 5.9.3 Rejected parts. 6 5.9.4 Drawing requirements. 6 6. NOTES 6 6.1 Intended use. 6 iii

Стр. 3

Downloaded from https://www.everyspec.com MIL-STD-1504C CONTENTS PARAGRAPHS PAGE 6.2 Subject term (key word) listing. 6 6.3 Changes from previous issue. 6 CONCLUDING MATERIALS 6 iv

Стр. 4