164 pp.
Department of Defense · MIL-STD-2001 · 32 pp.
MIL-STD-2001 Systems Operator's Interface Technical Manuals Writing Procedures PDF
Related manuals
21 pp.
25 pp.
26 pp.
291 pp.
26 pp.
26 pp.
40 pp.
Document text
Downloaded from https://www.everyspec.com MIL-STD-2001 14 January 1987 MILITARY STANDARD MANUALS, TECHNICAL, SYSTEMS OPERATOR’S INTERFACE: PROCEDURES FOR WRITING TMS S AMSC N/A DISTRIBUTION STATEMENT A. Approved for public release; distribution 1s unlimited.
Downloaded from https://www.everyspec.com MIL-STD-2001 Department of Defense Washington, DC 20301 Procedures for Writing Systems Operator’s Interface Technical Manuals 1. This military Standard is approved for use by all Departments and Agencies of the Department of Defense. 2. Beneficial comments (recommendations, additions, deletions) and any pertinent data which may be of use in improving this documet should be addressed to: Commandant of the Marine Corps, Headquart- ers, u.S. Marine Corps, (Code LMA-2) , Washington DC 20380-0001, by using the self addressed Standardization Document Improvement proposal (DD Form 1426) appearing at the end of this document or letter. L. ii
Downloaded from https://www.everyspec.com MIL-STD-2001 FOREWORD The increasing complexity and modularization of electronic equipment and the increasing necessity to adapt equipment systems for multiple uses has resulted in the development of new interface equipment and systems. These new items are cost effective develop- ments since they often enable communications equipment to be used for more than just one purpose. This standard establishes procedures for developing Systems Operator’s Interface Technical Manuals. It is not intended to duplicate other standards, specifications or manuals. -. iii
Downloaded from https://www.everyspec.com MIL-STD-2001 CONTENTS !?@!& Paragraph 1. SCOPE ................**...* ............* 1 1.1 1.2 1.3 Scope ................................. Applicability ......................... Purpose ............................... 1 1 1 2. REFERENCED DOCUMENTS., .................. 2 2.1 2.1.1 Government i.~cuments .......o.... ...... Specifications, standards, and handbooks ........................... Order of precedence ................... 2 2 2 2.2 3. DEFINITIONS ............................. 3 4. GENEIUIL REQUIREMENTS.. .................. 4 4.1 4.1.1 4 .1.2 4 .1.3 4 .1.4 Requirements .......................... Quality assurance provisions ..........
Preparation for delivery .............. Warnings, cautions and notes.. ........ Target population. .................... 4 4 4 4 4 5. DETAILED REQUIREMENTS ................... 5 5.1 5.1.1 5.1.1.1 5.1.2 5.1.3 5.1.3.1 5.1.3.2 Detailed requirements ................. Front matter .......................... Title ................................. Table of contents and chaper headings. Chapter 1 Introduction ................ General Information ................... Security procedures. .................. Destruction of equipment and access keys to prevent enemy use ........... Safety precautions pertaining to interface of the equipment. .........
tiow to use the equipment operator’s interface manual.. .................. Chapter 2: Equipment Interface ....... Section organization .................. General information ................... List of applicable technical manuals and documents fcr this particular interface ........................... Brief description of interface equipment .....................=..... 5 5 5 5 6 6 6 5.1.3.2.1 5.1.3.3. 7 7 5.1.3.4 7 8 8 9 5.1.4 5.1.4.1 5.1.4.1.1 5.1.4.1.1.1 9 9 .- 5.1.4.1.1.2 j-v